VC - Pre-AEC 8 Channel

NEXIA VC hardware is represented in the Layout with as many as seven separate blocks. Between these blocks can be placed virtually any of the other available NEXIA mixing, routing, and processing blocks (component objects). Like other component objects, NEXIA VC blocks can be placed into the Layout either from the Processing Library or from the Object Toolbar. To access VC – Pre-AEC 8 Channel settings, double-click over the corresponding block in the Layout. This opens a Control Dialog Box which provides all available settings.

When placing a Nexia VC into the Layout, the VC – Pre-AEC 8 Channel block is optional. It provides the same set of input signals as the VC - AEC Input 8 Channel block. However, the signals are derived from the input preamp directly, and are not affected by AEC or Noise Reduction processing. Pre-AEC input signals can be used to feed ‘local’ outputs, while the AEC input signals are used to feed the ‘far end’ (Codec Out).

Device IO indicates which hardware input is associated with that software channel. Peak In should flash only occasionally (6dB headroom), as determined by AEC Input Gain In settings. Mute In turns the input signal on/off. Level (dB) In adjusts the relative input volume. Invert In reverses the polarity of the input signal.

Right-clicking over certain settings will provide a menu of additional options.

Each NEXIA VC comes pre-configured from the factory with a default system design. If you wish to load your own custom designed configuration you will need to reset/initialize the unit(s) first.